Skip to content
CHILLY APS / ROBOTICS DEVELOPMENTDESIGN · BUILD · TEST · IMPROVE
ENGINEERING / FABRICATION

3D Printing

Bringing robot components into the physical world through iterative prototyping and practical testing.

01 / EQUIPMENT

Printing equipment

The original site identifies a Bambu Lab P2S with AMS 2 Pro, with a documented build volume of 256 × 256 × 256 mm. This information comes from the historical project description.

Printing equipment — original Robotics project image
02 / MATERIALS

Material selection

PETG was recorded as the starting material. ABS and polycarbonate were discussed as possible alternatives if later strength requirements warrant them, not as confirmed materials used.

IMAGE / TECHNICAL DRAWING SPACEFILAMENT & MATERIALSReserved for genuine project media
03 / PROTOTYPES

Print, test, revise

The development journal describes repeated printing and fit testing of servo holders, joint parts and leg components. Future entries can record settings, print times and dimensional adjustments.

IMAGE / TECHNICAL DRAWING SPACEPRINT ITERATIONSReserved for genuine project media